: A visual pinout for motor drivers, endstops, and laser modules is available on Scribd .

: Detailed PDF schematics and board layout images to help with connection setups.

Once connected via USB (usually at ), you may need to adjust these settings in the console: $100, $101, $102 : Steps per mm for X, Y, and Z. $32=1 : Enable Laser Mode (if using a laser).

Here are a few tips and tricks to help you get the most out of your MakerBase MKS DLC V21:

The MKS DLC V2.1 is a Laser Engraver Controller. The repository linked above contains everything you need: